Four section, folding,
full length padded mat. With 17.5 ins x 25
ins ‘Gripface’ rubber elbow panel
on one section, padded on three sections with
Polyethylene foam. The lower waterproof surface
is made of reinforced PVC, the upper surface
of shower-proofed heavy-duty cotton. Two carry
handles permit the folded mat to be used as
a carryall for other range equipment.
Four section lightweight
mat. A lightweight version padded with Polyethylene
foam only in the elbow panel. Intended for
the travelling shooter where bulk and weight
are a problem.
Single section padded
mat. Material specification as per the elbow
section of the full-length mat, with two carry
handles.
Groundsheet Mat, unpadded,
reinforced PVC with 25ins x 17.5ins ‘Gripface’
rubber panel. Rolls and ties with Velcro.
Single carry loop at one end. This mat is
ideal for Schools and Cadet Units where a
fully washable and rot-proof mat is essential.
‘Gripface’
rubber sheet pieces available up to 10 metres
long x 0.9m wide, suitable for attaching to
an existing mat or for use on its own.
Choice of limited colours available, subject
to stock availability. Colours liable to change
without notice.
“Gripface” Rubber
HPS Pro Master Shooting Gloves
Universal Mitt
For
those who prefer the easier fit of a mitt in place
of a glove, this soft well-padded ambidextrous
mitt has a sturdy reinforced pad between the thumb
and forefinger. Available in S, M, and L and in
one colour only.
Pro-Master
I
Pro
Master II
Pro
Master II - Fingerless
Pro
Master III
Pro
Master III - Fingerless
For those who prefer the
softer option, but with all the support and
a contour fit.
The best support a shooter
can get, contoured fit and maximum stiffness.
Supportive design, ideal
for positional shooting, ideal for changing air
rifle targets.
To give added grip, this
glove has 'Top Grip' surface material, it is supportive
yet supple.
Supportive design, ideal
for positional shooting, ideal for changing air
rifle targets.
Coaching
/ Plotting Thinsulate Lined Mitt/Glove
A thinsulate lined woollen half fingered glove
with a mitt pull which makes ideal coaching
/ plotting gloves on those cold days, allowing
use of your fingers when needed to record scores
or tweak sights with a mitt pullover to keep
your fingers warm the rest of the time. Available
in Medium, Large and Extra Large.
HPS
Strap on Elbow Pads
Made
from a sturdy, wear resistant, solid gripping
rubber with a soft lightly padded interior, and
two elasticised straps that fasten with Velcro,
which are secured from pulling through for ease
of fastening. A small white label has also been
added to one of the straps to allow for marking
a name or school identification. One size only.
HPS
Shooting Caps
HPS
Shooting Cap - Standard
Comes with fixed flaps that fold up, held in place
with Velcro.
HPS
Shooting Cap - Deluxe
Comes with integral sweat band, removable eye
blinder and flaps.
HPS
Head Bands
HPS
Head Band
Pure cotton for maximum comfort and absorption.
HPS
AKTIV-Flex Sling
Designed to overcome the problems with shallow
fore ended stocks and shooters of smaller
stature, where the sling either fouls on
the trigger guard or rubs on the underside
of the stock. This is a fully tuneable sling
to the shooters specific needs. A single
layer of non-stretch, reinforced PVC webbing,
with a wire centre section can be positioned
directly under the stock to give maximum
clearance. The front strap can be adjusted
to the size of hand and to clear the wrist.
The arm cuff can be adjusted in length for
arm size and position. The ‘pull’
can be tuned to the outer edge of the arm,
sling length is controlled by a buckle that
positions the ‘tail’ of the
sling outside of the position, so there
is no ‘congestion’ under the
rifle. The HPS AKTIV Flex Sling comes in
three colours - light blue (shown), dark
green and black.
HPS
Range Bags
Based on the original 1992 Palma range box designed for the GB Palma Team by Mike Pattinson, the box dismantles and folds flat for travel and will fit within a suitcase or double rifle box, taking up little space.
The box consists of two main parts, two alternative carry straps and an additional wet weather cover. Assembly is achieved using Velcro strips and turnbuckle fixings and takes less than one minute.
The box has an upper accessory tray and a lower body section. The front folds down to provide a sloping writing surface to which score cards may be rested. The top opens up to expose the tray. An adjustable shoulder strap may be clipped to either end and a shorter hand carry strap of fixed length may be used instead.
A separate folding wet weather cover may be fitted to the front to shield the front of the box. This is attached by two turn buckles and Velcro. It may be stored inside the box against the back wall when not in use.
Assembled size in carrying condition is 28 cm (H) x 42 cm (W) x 20 cm (D). Maximum ground area covered when opened with or without weather cover attached is approximately 42 cm square. Empty weight is 2.6 kg. Colour Green / Blue as shown.
HPS
Gun Bags
Padded
and reinforced gun bags with full-length zip and
large side pocket. Large Rubber nose cone to protect
ladder type foresights. Long enough and large
enough for a 32" long barrel rifle with sights
fitted. Also in extra large size to accept rifles
with 34” barrels and telescopic sights fitted.
Fully washable, available in blue only.
HPS
Rifle Gun Boxes
A double skinned moulded rifle
box made from heavy-duty polythene and lined with
eggshell foam with a recessed carrying handle,
four recessed lockable catches and riveted steel
hinges. The boxes come in two sizes - Single and
Double. Overall external box length is 135cm and
overall internal box length is 131cm. The internal
width of the Single Rifle box is 23cm, narrowing
to 19cm at the recessed carrying handle. The internal
width of the Double Rifle box is 33cm, narrowing
to 29cm at the recessed carrying handle. The Single
Rifle box will take a scoped or unscoped rifle.
The Double Rifle box will take two unscoped rifles
or one scoped and one unscoped rifle. These are
the strongest boxes we have ever found - see the
picture of one of our cars standing on one! Incredibly
good value at £60.00 including VAT for the
Single Rifle Box and £75.00 including VAT
for the Double Rifle Box.
Don't try this at home!
De/Re-Cocker
Tool
Designed to fit all models of Swing, Paramount,
all RPA and some other actions this tool is necessary
for de-cocking or re-cocking the bolt when dismantling/assembling
or for unloading the firing pin spring tension
when storing the rifle and bolt for long periods
of time.
Mirage
Bands
A
black elastic strip with wire loops at each end,
it stretches between the foresight and the rear
sight. It prevents heat mirage from the barrel
from affecting the sight picture. State barrel
length, foresight and rear sight types and action
make/model to enable correct supply of fixings.
Breech
Covers
A simple PVC cover that drops over the action
area of the rifle, held at the front by Velcro
strips and by the rear sight attachment. It shields
the action, loading port and bedding from rain.
An “o” ring is also included to stop
water running down under the barrel and into the
bedding. For use while shooting in the rain.
Wet
Weather Slips
A
stretch cover of waterproof fabric which fits
over the whole rifle to shield it from rain, dust
and dirt. For use when not shooting.
A limited range of colours avaliable.
HPS
Bar Towels
HPS Bar Towels useful for those Cold or Wet or Hot days!
